Tender for Ferritic Steel Sheet 10X1250x3000mm

Purchaser's Detail

Tender's Details

Ferritic Steel Sheet 10X1250x3000mm
Tender Doc. Cost (INR) : 0.00
Earnest Money (INR) : 0.00
Tender Closing Date Time : 21/10/2021 11:30
Tender Type : Limited - Indigenous
Contract Category : Expenditure
Evaluation Criteria : Itemwise/Consigneewise
Bidding System : Single Packet
Pre-Bid Conference Required : No
Pre-Bid Conference Date Time : Not Applicable
Tendering Section : 04
Inspection Agency : CONSIGNEE
Publishing Date / Time : 14/10/2021 12:17
Procure From Approved Sources : No
Approving Agency : Not Applicable

Description : FERRITIC STEEL COIL 1.25X1250MM., as per Drawing: RDSO SPEC NO.C-K201, GRADE X2CRNI12 (409M) TABLE 1 & 2, HEAT TREATMENT CONDITION 2B AS PER TABLE-5, COIL ID 450-650, OD 1000-1300MM, COIL WEIGHT 5-10 TONNES., Packing Instruction: STAINLESS STEEL (AUSTENITIC & FERRITIC STEEL COILS ETC.): THE COIL SHALL BE PROTECTED IN REASONABLY GOOD CONDITION TO WITHSTAND NORMAL HANDLING HAZARD DURING TRANSIT WITH THE FOLLOWING PROVISIONS AS THE BAREST MINIMUM: I) COIL SHOULD BE WRAPPED WITH A LAYER OF WATER PROOF PAPER THROUGHOUT THE WHOLE LENGTH. II) COIL SHOULD BE WRAPPED WITH A LAYER OF BIODEGRADABLE SHEET. III) OUTER & INNER OF COIL SHOULD BE WRAPPED WITH GI SHEET. IV) SIDE OF THE COIL SHOULD BE COVERED WITH CARD BOARD SHEET. V) AFTER THIS WHOLE COIL SHOULD BE WRAPPED WITH BIODEGRADABLE PLASTIC SHEET OF SUITABLE THICKNESS. VI) THE INNER EDGE OF THE COIL SHOULD BE PROTECTED BY GI RING, FOLLOWED BY ANOTHER IRON RING. VII) OUTER EDGE OF THE COIL SHOULD BE WRAPPED WITH GI RING. VIII) COIL SHOULD BE SECURELY STRAPPED WITH MINIMUM 5 STEEL BANDS THROUGH THE EYES OF THE COIL AND MINIMUM 3 STEEL BANDS ON THE CIRCUMFERENCE OF THE EYE. IX) WHOLE COIL SHOULD BE MOUNTED ON WOODEN BLOCKS FOR EASY LIFTING/STACKING.